ARTICLE |
|
Year : 2012 | Volume
: 2
| Issue : 2 | Page : 104-112 |
|
An Investigation into Dimensional Deviation Induced by Wire Electric Discharge Machining of High temperature Titanium alloy
Mohinder P Garg1, Ajai Jain2, Gian Bhushan2
1 Department of Mechanical Engineering, M. M. Engineering. College, Mullana, India 2 Department of Mechanical Engineering, N. I. T. Kurukshetra, Haryana, India
Correspondence Address:
Mohinder P Garg Department of Mechanical Engineering, M. M. Engineering. College, Mullana India
 Source of Support: None, Conflict of Interest: None  | Check |
DOI: 10.4103/0976-8580.99298
|
|
This article investigates the Wire Electric Discharge Machining of Titanium alloy 6-2-4-2. Six process parameters namely pulse-on time, pulse-off time, peak current, spark gap set voltage, wire feed, and wire tension are taken into account, to study their effect on dimensional deviation. The experiments are conducted using Box-Behnken designs. Empirical relation is developed between the process parameters and dimensional deviation by using regression analysis. Analysis of Variance is carried out to identify the significant process parameters affecting the process. Consequently, the optimal sets of parameters yielding the minimum dimensional deviation are obtained using the desirability approach. The optimal parameter combinations have been verified by conducting confirmation experiments. Results of the confirmation tests show that the developed mathematical models are appropriate for effective machining of Titanium alloy using Wire Electric Discharge Machining. |
|
|
|
[FULL TEXT] [PDF]* |
|
 |
|