Journal of Engineering and Technology

ARTICLE
Year
: 2013  |  Volume : 3  |  Issue : 2  |  Page : 105--112

Effect of machining parameters on dimensional deviation in wire electric discharge machining process using pure titanium


Anish Kumar1, Vinod Kumar2, Jatinder Kumar3 
1 Department of Mechanical Engineering, M.M. University, Mullana, Ambala, Haryana, India
2 Department of Mechanical Engineering, Thapar University, Patiala, Punjab, India
3 Department of Mechanical Engineering, National Institute of Technology, Kurukshetra, Haryana, India

Correspondence Address:
Anish Kumar
Department of Mechanical Engineering, M.M. University, Mullana, Ambala, Haryana
India

This study presents an investigation on wire electric discharge machining (WEDM) of pure titanium (grade-2). An attempt has been made to model the response variable dimensional deviation using the response surface methodology in a WEDM process. The experimental plan is based on Box-Behnken design. Six parameters such as pulse on time, pulse off time, peak current, spark gap voltage, wire feed, and wire tension were varied to investigate the effect on output response. The response has been optimized using the multi-objective optimization through desirability approach. The analysis of variance has been applied to identify the significance of the developed model. The test results confirm the validity and adequacy of the developed response surface methodology model. Finally, the optimum parametric setting is designed for the optimization of process .


How to cite this article:
Kumar A, Kumar V, Kumar J. Effect of machining parameters on dimensional deviation in wire electric discharge machining process using pure titanium.J Eng Technol 2013;3:105-112


How to cite this URL:
Kumar A, Kumar V, Kumar J. Effect of machining parameters on dimensional deviation in wire electric discharge machining process using pure titanium. J Eng Technol [serial online] 2013 [cited 2020 Feb 26 ];3:105-112
Available from: http://www.onlinejet.net/article.asp?issn=0976-8580;year=2013;volume=3;issue=2;spage=105;epage=112;aulast=Kumar;type=0